TMUX7208_V01 datasheet(25/51 Pages) TI

25 / 51 page

8 Parameter Measurement Information

8.1 On-Resistance

The on-resistance of a device is the ohmic resistance between the source (Sx) and drain (D) pins of the

device. The on-resistance varies with input voltage and supply voltage. The symbol RON is used to denote

on-resistance. The measurement setup used to measure RON is shown in Figure 8-1. Voltage (V) and current

(ISD) are measured using this setup, and RON is computed with RON = V / ISD:

RON

Figure 8-1. On-Resistance Measurement Setup

8.2 Off-Leakage Current

There are two types of leakage currents associated with a switch during the off state:

• Source off-leakage current

• Drain off-leakage current

Source leakage current is defined as the leakage current flowing into or out of the source pin when the switch is

off. This current is denoted by the symbol IS(OFF).

Drain leakage current is defined as the leakage current flowing into or out of the drain pin when the switch is off.

This current is denoted by the symbol ID(OFF).

The setup used to measure both off-leakage currents is shown in Figure 8-2.

GND

Is (OFF)

VDD

VSS

IS(OFF)

GND

VDD

VSS

ID(OFF)

ID (OFF)

Figure 8-2. Off-Leakage Measurement Setup

www.ti.com

TMUX7208, TMUX7209

SCDS418B – JULY 2020 – REVISED APRIL 2021

Submit Document Feedback

Product Folder Links: TMUX7208 TMUX7209

TMUX7208 데이터시트(PDF) 25 Page - Texas Instruments