MODEL: M6DXF3

M6DXF3 SPECIFICATIONS

ES-7849 Rev.4 Page 1/5

http://www.m-system.co.jp/

Euro Terminal Ultra-Slim Signal Conditioners M6D Series

HOLD FUNCTION MODULE

(PC programmable)

Functions & Features

• Track/Hold or Peak hold function’s selection available

• 5.9-mm wide ultra-slim design with DC current signal

input

• Low profile allows the M6D module to be mounted in a

120-mm deep panel

• PC programmable

• High-density mounting available

• Power and status indicator LEDs

Typical Applications

• Monitoring peak power consumption

• Monitoring the highest or lowest temperature

• Capturing signals from a composite analyzer performing

on each sample in turn

5.9 (.23)

94

(3.70)

102

(4.02)

mm (inch)

MODEL: M6DXF3–[1][2]–R[3]

ORDERING INFORMATION

• Code number: M6DXF3-[1][2]-R[3]

Specify a code from below for each [1] through [3].

(e.g. M6DXF3-Z1Z1-R/Q)

• Input range (e.g. 4 – 20 mA DC)

• Output range (e.g. 4 – 20 mA DC)

• Specify the specification for option code /Q

(e.g. /C01)

[1] INPUT

Current

Z1: Range 0 – 50 mA DC (Input resistance 24.9 Ω)

Voltage

S1: Range -1000 – +1000 mV DC (Input resistance 1 MΩ min.)

S2: Range -10 – +10 V DC (Input resistance 1 MΩ min.)

(Configurator software is used to change input over the

described range of the selected suffix code.

For changing between suffix codes, set the Input Range

Selector on the side of unit before software adjustment.)

[2] OUTPUT

Current

Z1: Range 0 – 20 mA DC

Voltage

V2: Range -10 – +10 V DC

V3: Range -5 – +5 V DC

(Configurator software is used to change output over the

described range of the selected suffix code.

For changing between suffix codes, set the Output Range

Selector on the side of unit before software adjustment.)

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[3] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

FUNCTIONS

PC Configurator Software is used to change function type.

• Track/Hold

• Peak hold

Peak hold

Valley hold

Peak-to-peak hold (Peak hold-Valley hold)

Factory default setting

Control/Hold: Track/Hold

Control/Control Logic: Hold at open

RELATED PRODUCTS

• PC configurator software (model: M6CFG)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.