DP8428 datasheet(2/26 Pages) NSC

2 / 26 page

General Description (Continued)

With its four independent RAS outputs and ten multiplexed

address outputs the DP8429 can support up to four banks

of 64k 256k or 1M DRAMs Two bank select pins B1 and

B0 are decoded to activate one of the RAS signals during

an access leaving the three non-selected banks in the

standby mode (less than one tenth of the operating power)

with data outputs in TRI-STATE

The DP8428’s one Bank

Select pin B1 enables 2 banks automatically during an ac-

cess in order to provide an optimum interface for 32-bit mi-

croprocessors

The DP8428 and DP8429 each have two mode-select pins

allowing for two refresh modes and two access modes Re-

fresh and access timing may be controlled either externally

or automatically The automatic modes require a minimum

of input control signals

A refresh counter is on-chip and is multiplexed with the row

and column inputs Its contents appear at the address out-

puts of the DP8428 or DP8429 during any refresh and are

incremented at the completion of the refresh Row Column

and bank address latches are also on-chip However if the

address inputs to the DP8428 or DP8429 are valid through-

out the duration of the access these latches may be operat-

ed in the fall-through mode

Each device is available in either the 52 pin Ceramic DIP or

the low cost JEDEC standard 68 pin Plastic Chip Carrier

(PCC) package

Functional Block Diagrams

DP8429

TLF8649 – 2

DP8428 데이터시트(PDF) 2 Page - National Semiconductor (TI)