| 전자부품 데이터시트 검색엔진 |
|
MCP47FXB0XT-EST 데이터시트(PDF) 77 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP47FXB0XT-EST 데이터시트(HTML) 77 Page - Microchip Technology |
|
77 / 124 page ![]() 2020 Microchip Technology Inc. DS20006368A-page 77 MCP47FXBX4/8 6.9 Entering High-Speed (HS) Mode The I2C specification requires that a High-Speed mode device be activated to operate in High-Speed (3.4 Mbit/s) mode. This is accomplished by the master sending a special address byte following the Start bit. This byte is referred to as the High-Speed Master Mode Code (HSMMC). The device can now communicate at up to 3.4 Mbit/s on SDA and SCL lines. The device will switch out of the HS mode on the next Stop condition. The master code is sent as follows: 1. Start condition (S) 2. High-Speed Master Mode Code (‘0000 1XXX’), The XXX bits are unique to the HS master mode. 3. No Acknowledge (A) After switching to the HS mode, the next transferred byte is the I2C control byte, which specifies the device to communicate with and any number of data bytes plus acknowledgments. The master device can then either issue a repeated Start bit to address a different device (at high-speed) or a Stop bit to return to the fast/standard bus speed. After the Stop bit, any other master device (in a Multi-Master system) can arbitrate for the I2C bus. The MCP47FXBX4/8 devices do not acknowledge the HS Select byte. However, upon receiving this command, the device switches to HS mode. Figure 6-3 illustrates the HS mode command sequence. For more information on the HS mode, or other I2C modes, refer to the “NXP I2C Specification”. 6.9.1 SLOPE CONTROL The slope control on the SDA output for the Fast/Stan- dard Speed is different from the one of the High-Speed clock modes of the interface. 6.9.2 PULSE GOBBLER The pulse gobbler on the SCL pin is automatically adjusted to suppress spikes < 10 ns during HS mode. FIGURE 6-3: HS Mode Sequence. S A ‘0000 1XXX’b Sr A Slave Address A/A Data P S = Start bit Sr = Repeated Start bit A = Acknowledge bit A = Not Acknowledge bit R/W = Read/Write bit R/W P = Stop bit (Stop condition terminates HS Mode) F/S mode HS mode HS mode continues F/S mode Sr A ‘Slave Address’ R/W HS Select Byte Control Byte Command/Data Byte(s) Control Byte |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |