AIS2IH datasheet(35/63 Pages) STMICROELECTRONICS

35 / 63 page

8.5

CTRL2 (21h)

Control register 2 (r/w)

Table 31. Control register 2

BOOT

SOFT_

RESET

0(1)

CS_PU_

DISC

BDU

IF_ADD_ INC

I2C_

DISABLE

SIM

1. This bit must be set to ‘0’ for the correct operation of the device.

BOOT

Boot enables retrieving the correct trimming parameters from nonvolatile memory into registers where

trimming parameters are stored.

Once the operation is over, this bit automatically returns to 0.

Default value: 0 (0: disabled; 1: enabled)

SOFT_RESET

Soft reset acts as reset for all control registers, then goes to 0.

Default value: 0 (0: disabled; 1: enabled)

CS_PU_DISC

Disconnect CS pull-up. Default value: 0

(0: pull-up connected to CS pin;

1: pull-up disconnected to CS pin)

BDU

Block data update. Default value: 0

(0: continuous update; 1: output registers not updated until MSB and LSB read)

IF_ADD_INC

Default value: 1 (0: disabled; 1: enabled)

I2C_DISABLE

Disable I²C communication protocol. Default value: 0

(0: SPI and I²C interfaces enabled; 1: I²C mode disabled)

SIM

SPI serial interface mode selection. Default value: 0

0: 4-wire interface; 1: 3-wire interface

The BDU bit is used to inhibit the update of the output registers until both upper and lower register parts are

read. In default mode (BDU = ‘0’) the output register values are updated continuously. When the BDU is activated

(BDU = ‘1’), the content of the output registers is not updated until both MSB and LSB are read which avoids

reading values related to different sample times.

AIS2IH

CTRL2 (21h)

DS12421 - Rev 4

page 35/63

AIS2IH 데이터시트(PDF) 35 Page - STMicroelectronics

AIS2IH 데이터시트(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

데이터시트 다운로드

링크 URL