MODEL: R1C-GH

R1C-GH SPECIFICATIONS

ES-5956 Rev.12 Page 1/5

http://www.m-system.co.jp/

Remote I/O R1X Series

THERMOCOUPLE & DC INPUT MODULE

(16 points; CC-Link Ver.1.10/Ver.2.00)

Functions & Features

• 16-point thermocouple or DC inputs

• CC-Link interface

• CC-Link Version 1.10 and 2.00 can be switched at the

startup

40

(1.57)

115

(4.53)

mm (inch)

175 (6.89)

MODEL: R1C-GH2T-[1][2]

ORDERING INFORMATION

• Code number: R1C-GH2T-[1][2]

Specify a code from below for each [1] and [2].

(e.g. R1C-GH2T-M2/Q)

• Specify the specification for option code /Q

(e.g. /C01)

• Use Ordering Information Sheet (No. ESU-5956). Default

setting will be used if not otherwise specified.

Factory default setting

Input type: DC Voltage ±5 V

Burnout protection: No burnout

Cold junction compensation: No

FIELD TERMINAL TYPE

T: M3 screw terminals

[1] POWER INPUT

AC Power

M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,

47 – 66 Hz)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[2] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• Resistor module (model: REM3-250)

• R1X configurator software (model: R1CON)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

PACKAGE INCLUDES...

• Terminating resistor (110 Ω, 0.5 W)

GENERAL SPECIFICATIONS

Connection

Power input, CC-Link: Euro type connector terminal

stripped length 7 mm)

Input: M3 screw terminals (torque 0.6 N·m)

Configurator: 2.5 dia. miniature jack; RS-232-C level

Screw terminal: Nickel-plated steel

Housing material: Flame-resistant resin (gray)

Isolation: Input to CC-Link (FG) to power

PWR indicator: Green LED blinks in normal conditions.

CC-Link COMMUNICATION

Protocol: CC-Link V1.10 / V 2.00

Cable for comm. link: Specified by Mitsubishi Electric

Required nodes

V. 1.10: 4

V. 2.00: 1 (cyclic expansion: 4)

Station No. setting: Rotary switch

V. 1.10: Rotary switch; 1 – 61

V. 2.00: Rotary switch; 1 – 64

Baud rate setting: Rotary switch

L RUN indicator: Red LED turns on in normal conditions.

L ERR. indicator: Red LED turns on or blinks in an

abnormality.

SD indicator: Red LED turns on when transmitting.

RD indicator: Red LED turns on when receiving.

INPUT SPECIFICATIONS

■ Thermocouple or DC input, 16 points

(Common negative for DC input)

•Measuring range ±20 V, ±5 V, ±1 V: Atten. SW ON (3)