ACE25QC160GLDPTH datasheet(28/73 Pages) ACE

28 / 73 page

ACE25QC160G

16M BIT SPI NOR FLASH

VER 1.2

Fast Read (0Bh) in QPI Mode

The Fast Read instruction is also supported in QPI mode. When QPI mode is enabled, the number of

dummy clocks is configured by the “Set Read Parameters (C0h)” instruction to accommodate a wide range

of applications with different needs for either maximum Fast Read frequency or minimum data access

latency. Depending on the Read Parameter Bits P[5:4] setting, the number of dummy clocks can be

configured as either 2, 4, 6 or 8. The default number of dummy clocks upon power up or after a Reset

instruction is 2.

Dual Output Fast Read (3BH)

See Figure 9, the Dual Output Fast Read instruction is followed by 3-byte address (A23-A0) and a dummy

byte, each bit being latched in during the rising edge of SCLK, then the memory contents are shifted out

2-bit per clock cycle from SI and SO. The first byte addressed can be at any location. The address is

automatically incremented to the next higher address after each byte of data is shifted out.

Figure9. Dual Output Fast Read Sequence Diagram (SPI Mode only)

Figure8 b. Fast Read Sequence Diagram (QPI Mode)

ACE25QC160GLDPTH 데이터시트(PDF) 28 Page - ACE Technology Co., LTD.