PSD311 datasheet(36/85 Pages) STMICROELECTRONICS

36 / 85 page

PSD3XX Family

All the inputs shown, except CSI, go to the PAD logic. These signals must be taken into

consideration when calculating the composite frequency. Before we make the calculation,

let’s establish the following conditions:

• The input with the highest frequency is ALE, which is 2 MHz. So our base period is

500 nsec for this example.

• Only the address information from the multiplexed signals AD0-AD7 reach the PAD

logic because of the internal address latch. Signal transitions from data on AD0-AD7

do not reach the PADs.

• The three inputs (Int, Sel, or Rdy) change state very infrequently relative to the 80C31

bus signals.

Now, lets assume the following is a snapshot in time of all the input signals during a typical

80C31 bus cycle. We’ll use a code fetch as an example since that happens most often.

16.0

Power

Management

(cont.)

ONE TYPICAL 80C31 BUS CYCLE (2 MHz, 500 nsec)

ALE

PSEN

AD0-AD7

A8-A15

INT

SEL

RDY

FOUR DISTINCT

TRANSITIONS

< 25 nsec

ADDR

DATA

The calculation of the composite frequency is as follows:

• There are four distinct transitions (first four dotted lines) within the base period of

500 nsec. These first four transitions all count toward the final composite frequency.

• The transition at (1) in the diagram does not count as a distinct transition because it is

within 25 nsec of a neighboring transition (use 50 nsec for a ZPSD3XXV device).

• Transition (2) above does not add to the composite frequency because only the

internally latched address signals reach the PADs, the data signal transitions do not.

• The transition at (3) just happens to appear in this snapshot, but its frequency is so

low that it is not a significant contributor to the overall composite frequency, and will

not be used.

• Divide the 500 nsec base period by the four (distinct transitions), yielding 125 nsec.

1/125 nsec = 8 MHz.

• Use 8 MHz as the composite frequency of PAD inputs when calculating current

consumption. (See the next section for a sample current calculation.)

16.6 Loading on I/O pins

A final consideration when calculating the current usage for the entire PSD device is the

loading on I/O pins. All specifications for PSD current consumption in this document

assume zero current flowing through PSD I/O pins (including ADIO). I/O current is dictated

by the individual design implementation, and must be calculated by the designer. Be aware

that I/O current is a function of loading on the pins and the frequency at which the signals

toggle.

PSD311 데이터시트(PDF) 36 Page - STMicroelectronics

PSD311 데이터시트(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

데이터시트 다운로드

링크 URL