PLL103-01

Low Skew Buffers

47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991

Rev 03/08/00 Page 3

I2C BUS CONFIGURATION SETTING

Address Assignment

A6

A5

A4

A3

A2

A1

A0

R/W

1

1

0

1

0

0

1

_

Slave

Receiver/Transmitter

Provides both slave write and readback functionality

Data Transfer Rate

Standard mode at 100kbits/s

Data Protocol

This serial protocol is designed to allow both blocks write and read from the controller. The

bytes must be accessed in sequential order from lowest to highest byte. Each byte transferred

must be followed by 1 acknowledge bit. A byte transferred without acknowledged bit will

terminate the transfer. The write or read block both begins with the master sending a slave

address and a write condition (0xD2) or a read condition (0xD3).

Following the acknowledge of this address byte, in

Write Mode: the Command Byte and Byte

Count Byte must be sent by the master but ignored by the slave, in Read Mode: the Byte

Count Byte will be read by the master then all other Data Byte. Byte Count Byte default at

power-up is = (0x09).

I2C CONTROL REGISTERS

1. BYTE 0: SDRAM(0:7) Clock Register (1=Enable, 0=Disable)

Bit

Pin#

Default

Description

Bit 7

18

1

SDRAM7 (Active/Inactive)

Bit 6

17

1

SDRAM6 (Active/Inactive)

Bit 5

14

1

SDRAM5 (Active/Inactive)

Bit 4

13

1

SDRAM4 (Active/Inactive)

Bit 3

9

1

SDRAM3 (Active/Inactive)

Bit 2

8

1

SDRAM2 (Active/Inactive)

Bit 1

5

1

SDRAM1 (Active/Inactive)

Bit 0

4

1

SDRAM0 (Active/Inactive)