Issue:1836

In the effort to improve our products, we reserve the right to make changes judged to be necessary.

CONFIDENTIAL AND PROPRIETARY INFORMATION

This document contains confidential and proprietary information of Pulse Electronics, Inc. (Pulse) and is protected by copyright, trade secret and other state and federal laws.

Its receipt or possession does not convey any rights to reproduce, disclose its contents, or to manufacture, use or sell anything it may describe. Reproduction, disclosure or

use without specific written authorization of Pulse is strictly forbidden.

Description: UltraThin, clear radome

antenna for iDAS

PART NUMBER: DASUTCCxxx

Series: CLARITY

20

ASSEMBLY

Installation

1. Drill or cut a hole 2.5-2.75 inches (64-70 mm) diameter at the center of the

ceiling tile or at the desired location. Slide the antenna cable/connector

assembly through the hole. Slide the Collar and Nut onto the cable. Turn the

Nut, tightening the antenna against the ceiling tile. See

Note: Fiberboard ceiling tile is soft; tighten the nut just enough to hold the

antenna firmly in place.

If using the reflector, thread the reflector onto the Antenna Stem before

attaching the connectors. See Figure 2.