USB2GPIO datasheet(2/11 Pages) MAXIM

2 / 11 page

Maxim Integrated │ 2

www.maximintegrated.com

Evaluates: USB2GPIO

USB2GPIO# Adapter Board

Quick Start

Required Equipment

● PC with Windows OS (Windows 7, Windows 8, or

Windows 10) with a USB port

● USB2GPIO# board

● A-to-Micro-B USB cable (not supplied)

● Munich software V2.17 or later

● Supported I2C or SPI interface device for communication

like MAX14001PMB# board

Procedure

The USB2GPIO# is fully assembled and tested. Follow

the steps below to verify board operation:

1) Go to

www.maximintegrated.com/evkitsoftware

to download the most recent version of the Munich

GUI software,

MUNICH GUI. Save the software to a

temporary folder and decompress the

Munich_GUI-

SetupV2.17.zip file.

2) Connect the USB cable between the USB2GPIO#

board and the PC; the USB driver is installed

automatically.

3) Ensure that the companion SPI interface device’s

jumper settings are correct. Refer to your companion

device’s documentation.

4) Connect the USB2GPIO# board’s 2 x 6-pin, right-

angle connector to the companion device’s 2 x 6-pin,

right-angle header, as shown in Figure 2.

5) Once the USB2GPIO# board is connected to the

companion device, open the

MUNICH GUI.exe

(double-click) software.

6) Start the Munich GUI software and select the tab

sheet that corresponds to the companion device.

Follow instructions in the companion device data

sheet to test it in conjunction with USB2GPIO#.

Figure 2. USB2GPIO# Board Connected with MAX14914PMB#

USB2GPIO 데이터시트(PDF) 2 Page - Maxim Integrated Products

USB2GPIO 데이터시트(HTML) 2 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8 9 10 11

데이터시트 다운로드

링크 URL