EMC6D102 datasheet(21/86 Pages) SMSC

21 / 86 page

Fan Control Device with Hardware Monitoring and Acoustic Noise Reduction Features

Datasheet

SMSC EMC6D102

Revision 0.4 (04-05-05)

DATASHEET

5.4

Interrupt Status Registers

The Hardware Monitor Block contains two interrupt status registers: Register 41h: Interrupt Status

voltage and fan violation of limit error conditions and diode fault conditions that the Hardware Monitor

Block monitors.

When an error occurs during the conversion cycle, its corresponding bit is set in its respective interrupt

status register. The bit remains set until the register is read by software, at which time the bit will be

cleared to ‘0’ if the associated error event no longer violates the limit conditions or if the diode fault

condition no longer exists. Reading the register will not cause a bit to be cleared if the source of the

status bit remains active.

These registers are read only – a write to these registers have no effect. These registers default to

0x00 on VCC POR and Initialization.

See the description of the Interrupt Status registers in Chapter 7, "Register Set," on page 45.

Each interrupt status bit has a corresponding bit located in an interrupt enable register, which may be

used to enable/disable the individual event from setting the status bit. See the figure below for the

status and enable bits used to control the interrupt bits and INT# pin.

EMC6D102 데이터시트(PDF) 21 Page - SMSC Corporation