GLQ110 datasheet(7/109 Pages) EMERSON-NETWORKPOWER

7 / 109 page

GLQ142 Installation & Operating Instructions

Visit our Web site at www.solahd.com or contact Technical Support at (800) 377- 4384 with any questions

P/N: A272-177 Rev 0 6/1/09 Ref: LPQ142/OP.C

To comply with the published safety standards, the following must be observed when using

this power supply:

1. Maximum ambient temperature for the power supply must not exceed 50°C. Derate

each output 2.5% per degree from 50°C to 70°C ambient temperature.

2. When installing the power supply in the end-use equipment, special attention is

required to ensure safety compliance with the following safety standards: UL60950-1,

EN60950-1, IEC60950-1, and CSA22.2 No. 60950-1-03; including the requirements

for creepage distances, clearances, and distance through insulation between primary

wiring and earth or secondary (SELV) wiring.

3. The ac-dc input connector is approved as a component of the power supply, however, it

was not specifically evaluated to IEC60320.

4. This power supply is approved and certified for the rated voltage range of 100 V ac to

250 V ac and/or 120 V dc (minimum) to 370 V dc (maximum).

5. The earth ground wire must be connected only to the point marked with the earth

ground symbol (on the unit).

6. The disconnection from the line must be in the end system.

7. When operating with a dc input voltage range, the dc source must be rectified from a

mains supply not exceeding 250 V ac. The unit input must also be protected by a dc

rated fuse in the end-use installation system.

8. The internal fuse (F1) should only be replaced by a 4 A, 250 V ac, type GDA-V/S501

manufactured by Bussman.

9. This equipment is considered Class I according to protection against electric shock.

10. This power supply is

marked following the provisions of the Low Voltage Directive,

2006/95/EC.

11. For technical assistance, contact SolaHD Technical Support at (800) 377- 4384 or send

an e-mail to tech@solahd.com. Please visit our Web site at www.solahd.com for addi-

tional product information and specification sheets.

Output Ratings

Output Voltage (V)

Convection Cooling

30 CFM Forced Air Cooling

Max. Output

Current (A)

Max. Output

Power (W)

Max. Output

Current (A)

Max. Output

Power (W)

V1:

+3.3 to +5.7

12.0

80 without cover

60 with cover

25.0

145 with or without

cover

145 with cover &

internal fan

V2:

+12.0 to +12.7

5.0

6.0

V3:

-12.0 to -15.0

1.0

1.5

V4:

+3.3 to +25.0

1.5

4.5

Mechanical Outline

SK5

SK2

SK6

P252

P251

SK3

V4 Adj.

Fine Course

Adj.

SK1

Connector PIN Designation

Input Connector

Designation

SK1

Earth GND

Neutral

Line

Output Connector

Designation

SK2

2, 4

Common

V4 (Return)

SK3

P251

Common

P252

SK5

(optional for units with cover & fan)

Common

SK6

V4 SWP (Single Wire Parallel)

Dc OK

+V4 Sense

V1 SWP (Single Wire Parallel)

Common

+V1 Sense

Sense Common

+Inhibit

-Inhibit

Power Fail

GLQ110 데이터시트(PDF) 7 Page - Emerson Network Power

GLQ110 데이터시트(HTML) 7 Page - Emerson Network Power

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL