Copyright © 2017 Linx Technologies

159 Ort Lane, Merlin, OR 97532

Phone: +1 541 471 6256

Fax: +1 541 471 6251

www.linxtechnologies.com

by

ANT-2.4-CW-RH Data Sheet

Counterpoise

Quarter-wave or monopole antennas require an associated ground plane counterpoise for proper operation.

The size and location of the ground plane relative to the antenna will affect the overall performance of the

antenna in the final design. When used in conjunction with a ground plane smaller than that used to tune the

antenna, the center frequency typically will shift higher in frequency and the bandwidth will decrease. The

proximity of other circuit elements and packaging near the antenna will also affect the final performance. For

further discussion and guidance on the importance of the ground plane counterpoise, please refer to Linx

Application Note AN-00501: Understanding Antenna Specifications and Operation.

VSWR Graph

3:1

2:1

1:1

2350MHz

2450MHz

2550MHz

VSWR

1.401

25%

11%

0%

Reflected Power

What is VSWR?

The Voltage Standing Wave Ratio (VSWR) is a measurement of how well an antenna is matched to a source

impedance, typically 50-ohms. It is calculated by measuring the voltage wave that is headed toward the load

versus the voltage wave that is reflected back from the load. A perfect match has a VSWR of 1:1. The higher

the first number, the worse the match, and the more inefficient the system. Since a perfect match cannot

ever be obtained, some benchmark for performance needs to be set. In the case of antenna VSWR, this

is usually 2:1. At this point, 88.9% of the energy sent to the antenna by the transmitter is radiated into free

space and 11.1% is either reflected back into the source or lost as heat on the structure of the antenna. In

the other direction, 88.9% of the energy recovered by the antenna is transferred into the receiver. As a side

note, since the “:1” is always implied, many data sheets will remove it and just display the first number.

How to Read a VSWR Graph

VSWR is usually displayed graphically versus frequency. The lowest point on the graph is the antenna’s

operational center frequency. In most cases, this is different than the designed center frequency due to

fabrication tolerances. The VSWR at that point denotes how close to 50-ohms the antenna gets. Linx

specifies the recommended bandwidth as the range where the typical antenna VSWR is less than 2:1.