ML5954 datasheet(5/6 Pages) MINILOGIC

5 / 6 page

_______________________________________________________________

ML5954

BTL Driver for CD-ROM Drivers & DVD Player

May, 2004 V1.0

Application Circuit

ML5954

DSP

5V or 12V

FOCUS COIL

TRACKING COIL

SLED MOTOR

MOTOR

12V

5V or 12V

Micro-controller

Precautions for use

(1) This IC has a built-in thermal shutdown circuit that mutes the output current when the chip temperature reached

175oC (Typ). The hysteresis is set to 25 oC (Typ.), so the driver circuits start up again when the chip temperature falls

to 150 oC (Typ.).

(2) The driver buffer is switched off when the supply voltage falls below 3.5V (Typ.), and is switched back on when the

voltage reaches 3.7V (Typ.) again.

(3) In case standby pin voltage under 1.4V or opened, quiescent current is muted. Standby pin voltage should be over

1.8V for normal application.

(4) Insert the by-pass capacitor between VCC-pin and GND-pin of the IC as near as possible (approximately 0.1uF)

(5) Heat dissipation fins are attached to the GND on the inside of the package. Make sure to connect these to the external

GND.

Supplement: (Current-feedback driver)

The transmission gain (output current/input voltage) is given by :

)

(

)

(

WIRE

,where RWIRE is the total gold wire resistance inside the package (0.15Ω ± 0.05Ω) (Typ.).

5/6

ML5954 데이터시트(PDF) 5 Page - Minilogic Device Corporation Limited