STM32F302X8 datasheet(41/139 Pages) STMICROELECTRONICS

부품명	STM32F302X8

상세설명	Arm® Cortex®-M4 32-bit MCUFPU, up to 64 KB Flash, 16 KB SRAM, ADC, DAC, USB, CAN, COMP, Op-Amp, 2.0 - 3.6 V

PDF	139 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

41 / 139 page

BOOT0

Boot memory selection

PB8

I/O

FTf

TIM16_CH1, TSC_SYNC,

I2C1_SCL, USART3_RX, CAN_RX,

TIM1_BKIN, EVENTOUT

PB9

I/O

FTf

TIM17_CH1, I2C1_SDA, IR-OUT,

USART3_TX, COMP2_OUT,

CAN_TX, EVENTOUT

VSS_1

Digital ground

“1”

VDD_1

Digital power supply

1. PC13, PC14 and PC15 are supplied through the power switch. Since the switch sinks only a limited amount of current (3 mA), the use of GPIO PC13 to PC15 in output

mode is limited:

- The speed should not exceed 2 MHz with a maximum load of 30 pF

- These GPIOs must not be used as current sources (e.g. to drive an LED).

After the first backup domain power-up, PC13, PC14 and PC15 operate as GPIOs. Their function then depends on the content of the Backup registers which is not reset by

the main reset. For details on how to manage these GPIOs, refer to the Battery backup domain and BKP register description sections in the RM0365 reference manual.

2. Fast ADC channel.

3. These GPIOs offer a reduced touch sensing sensitivity. It is thus recommended to use them as sampling capacitor I/O.

Table 13. STM32F302x6/8 pin definitions (continued)

Pin Number

Pin name

(function after reset)

Alternate

functions

Additional

functions

STM32F302X8 데이터시트(PDF) 41 Page - STMicroelectronics

STM32F302X8 데이터시트(HTML) 41 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL