ALD2302/ALD2302A

Advanced Linear Devices, Inc.

6 of 9

TYPICAL APPLICATIONS (cont'd)

Design & Operating Notes:

1. As each output sources up to 10mA in the output high state, the output stage of a wired - OR low output circuit must be able to sink this current and still

provide desired output voltage levels. For TTL output levels, this consideration limits the number to a maximum of three ALD2302 outputs wired-OR

together.

2. In order to minimize stray oscillation, all unused inputs must be tied to ground.

3. The input bias and offset currents are essentially input protection diode reverse bias leakage currents, and are typically less than 1pA at room

temperature. The currents are a function of ambient temperature, and would have to be considered in applications where very high source impedance

or high accuracy are involved.

4. The high output sinking current of 60mA for each output offers flexibility in many applications, as a separate buffer or driver would not be necessary to

drive the intended load. However, as the circuit normally operates close to ambient temperature due to its very low power consumption, thermal effects

caused by large output current transients must be considered in certain applications.

PUSH-PULL COMPLEMENTARY POWER MOSFET DRIVER

TIME DELAY GENERATOR

This circuit eliminates crossover current in the

complementary power transistors. The outputs can

be used to source and sink different loads or tied

together to provide push-pull drive of the same load.

+

+

+12V

+12V

+12V

P- Channel VP 02

Power MOSFET

2A Source

2A Sink

N - Channel VN 01

Power MOSFET

+12V

10K

40K

10K

ALD2302

+

1/2 ALD 2302

1/2 ALD 2302

+

1/2 ALD 2302

+

1/2 ALD 2302

+