PCA9541ADSLASH01 datasheet(8/45 Pages) NXP

8 / 45 page

PCA9541A

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 5 — 24 April 2014

8 of 45

NXP Semiconductors

PCA9541A

2-to-1 I2C-bus master selector with interrupt logic and reset

7.3 Interrupt Enable and Control registers description

When a master seeks control of the bus by connecting its I2C-bus channel to the

PCA9541A downstream channel, it has to write to the CONTROL register (Reg#01).

Bits MYBUS and BUSON allow the master to take control of the bus.

The MYBUS and the NMYBUS bits determine which master has control of the bus.

Table 9 explains which master gets control of the bus and how. There is no arbitration.

Any master can take control of the bus when it wants regardless of whether the other

master is using it or not.

The BUSON and the NBUSON bits determine whether the upstream bus is connected or

disconnected to/from the downstream bus. Table 10 explains when the upstream bus is

connected or disconnected.

Internally, the state machine does the following:

• If the combination of the BUSON and the NBUSON bits causes the upstream to be

disconnected from the downstream bus, then that is done. So in this case, the values

of the MYBUS and the NMYBUS do not matter.

• If a master was connected to the downstream bus prior to the disconnect, then an

interrupt is sent on the respective interrupt output in an attempt to let that master know

that it is no longer connected to the downstream bus. This is indicated by setting the

BUSLOST bit in the Interrupt Status Register.

• If the combination of the BUSON and the NBUSON bits causes a master to be

connected to the downstream bus and if there is no change in the BUSON bits since

when the disconnect took effect, then the master requesting the bus is connected to

the downstream bus. If it requests a bus initialization sequence, then it is performed.

• If there is no change in the combination of the BUSON and the NBUSON bits and a

new master wants the bus, then the downstream bus is disconnected from the old

master that was using it and the new master gets control of it. Again, the bus

initialization if requested is done. The appropriate interrupt signals are generated.

After a master has sent the bus control request:

1. The previous master is disconnected from the I2C-bus. An interrupt to the previous

master is sent through its INT line to let it know that it lost control of the bus.

BUSLOST bit in the Interrupt Status Register is set. This interrupt can be masked by

setting the BUSLOSTMSK bit to logic 1.

Fig 7.

Internal register map

002aae660

IE 0

CONTROL 0

ISTAT 0

IE 1

CONTROL 1

ISTAT 1

PCA9541A

REG#00

REG#01

REG#10

CONTROL

ISTAT

MASTER 0

SCL_MST0

SDA_MST0

REG#00

REG#01

REG#10

CONTROL

ISTAT

MASTER 1

SCL_MST1

SDA_MST1

PCA9541AD/01 데이터시트(PDF) 8 Page - NXP Semiconductors

PCA9541AD/01 데이터시트(HTML) 8 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

데이터시트 다운로드

링크 URL