PIC10F200 datasheet(72/86 Pages) MICROCHIP

72 / 86 page

PIC10F200/202/204/206

DS41239B-page 70

Preliminary

TABLE 12-4:

CALIBRATED INTERNAL RC FREQUENCIES – PIC10F200/202/204/206

FIGURE 12-3:

RESET, WATCHDOG TIMER AND DEVICE RESET TIMER TIMING –

PIC10F200/202/204/206

AC CHARACTERISTICS

Standard Operating Conditions (unless otherwise specified)

Operating Temperature

-40

°C ≤ TA ≤ +85°C (industrial),

-40

°C ≤ TA ≤ +125°C (extended)

Operating Voltage VDD range is described in

Section 12.1 “DC Characteristics”.

Param

No.

Sym

Characteristic

Freq

Tolerance

Min

Typ†

Max

Units

Conditions

F10

FOSC

Internal Calibrated

INTOSC Frequency(1)

± 1%

7.92

4.00

8.08

MHz VDD and Temperature TBD

± 2%

7.84

4.00

8.16

MHz 2.5V

≤ VDD ≤ 5.5V

Temperature TBD

± 5%

7.60

4.00

8.40

MHz 2.0V

≤ VDD ≤ 5.5V

-40

°C ≤ TA ≤ +85°C (industrial)

-40

°C ≤ TA ≤ +125°C (extended)

Legend: TBD = To Be Determined.

These parameters are characterized but not tested.

† Data in the Typical (“Typ”) column is at 5V, 25

°C unless otherwise stated. These parameters are for design

guidance only and are not tested.

Note 1:

To ensure these oscillator frequency tolerances, VDD and VSS must be capacitively decoupled as close to

the device as possible. 0.1

μF and 0.01 μF values in parallel are recommended.

VDD

MCLR

Internal

POR

DRT

Timeout(2)

Internal

Reset

Watchdog

Timer

Reset

I/O pin(1)

Note

I/O pins must be taken out of High-Impedance mode by enabling the output drivers in software.

Runs on POR only.

PIC10F200 데이터시트(PDF) 72 Page - Microchip Technology

PIC10F200 데이터시트(HTML) 72 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

데이터시트 다운로드

링크 URL