User manual

17

Revision 1.1

2020-09-29

EVAL-M1-IM240-A user manual

iMOTION™ modular application design kit

Getting started with EVAL-M1-IM240-A

Note: On-board Debugger portion of EVAL-M1-101T is galvanically isolated from the controller portion and the

attached power board. In order to program the parameters or firmware to the IMC101T-T038 controller, the

3.3 V DC voltage needs to be supplied to the controller portion of the EVAL-M1-101T. This voltage can either

be supplied by the power board (MADK power boards are designed to supply the 3.3 V to the control board

through M1 connector) or by feeding the 3.3 V DC voltage to the control board through some of the available

3.3 V access/test points if the power board is not attached to the EVAL-M1-101T control board.

To program new firmware and drive system parameter into IMC101T-T038, please click “Tools” menu and

select “Programmer” in the pull down list. The pop-up window “Program IMC controller” will show up as in

Figure 10. Click on the “Program Firmware and Parameter” radio button, and select the drive system parameter

file created using MCEWizard by clicking on the “Browse” button on the row of “Program Parameter File”, and

then select the firmware file by clicking on the “Browse” button on the row of “Program Firmware File”. Finally,

click on the “Start” button to program the parameter file into the IMC101T-T038 IC.

Figure 10 Program firmware and parameter in “Program IMC Controller” pop-up window