User Manual

19 of 41

Revision 1.6

2019-07-16

EVAL-M3-102T User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M3-102T

MCEDesigner programmer function can be used to program IMC101T-T038 firmware and/or System

parameters. To call this function, click on “Tools” menu and then select “Programmer” in the pull down list.

The pop-up window “Program IMC controller” will show up as in Figure 9.

To program both firmware and Drive System Parameters into IMC102T-F064 (which can happen when

programming for the first time the brand new devices with default factory setting, or when the new version of

iMOTION™ firmware is being downloaded), first click on the “Program Firmware and Parameter” radio button in

the “Program IMC controller” pop-up window. After that, select the Drive System Parameter file created using

MCEWizard by clicking on the “Browse…” button at the end of the “Program Parameter File” row, and then also

select the the IMC102T-F064_A_Vxxx.ldf file (which was included in the “IMC102T-F064 MCE Software Package”)

by clicking on the “Browse…” button at the end of “Program Firmware File” row. Finally, click on the “Start”

button to program the parameter file into the IMC102T-F064 IC.

Figure 9

Program Firmware and Parameter in “Program IMC Controller” pop-up window

To program only Drive System Parameter file into IMC102T-F064, click on “Tools” menu and select

“Programmer” in the pull down list. The pop-up window “Program IMC controller” will show up as in Figure 10.

Click on the “Program Parameters” radio button (this is the default option), and then select the Drive System

Parameter file created using MCEWizard by clicking on “Browse…”. Finally, click on the “Start” button to

program the parameter file into the IMC102T-F064 IC.