3

Raspberry Pi 3 Model B+

raspberrypi.org

Warnings

Safety instructions

This product should only be connected to an external power supply rated at 5V/2.5A DC. Any external power

supply used with the Raspberry Pi 3 Model B+ shall comply with relevant regulations and standards applicable

in the country of intended use.

This product should be operated in a well-ventilated environment and, if used inside a case, the case should

not be covered.

Whilst in use, this product should be placed on a stable, flat, non-conductive surface and should not be

contacted by conductive items.

The connection of incompatible devices to the GPIO connection may affect compliance, result in damage to

the unit, and invalidate the warranty.

All peripherals used with this product should comply with relevant standards for the country of use and be

marked accordingly to ensure that safety and performance requirements are met. These articles include but

are not limited to keyboards, monitors, and mice when used in conjunction with the Raspberry Pi.

The cables and connectors of all peripherals used with this product must have adequate insulation so that

relevant safety requirements are met.

To avoid malfunction of or damage to this product, please observe the following:

Do not expose to water or moisture, or place on a conductive surface whilst in operation.

Do not expose to heat from any source; the Raspberry Pi 3 Model B+ is designed for reliable operation at normal

ambient temperatures.

Do not expose the printed circuit board to high-intensity light sources (e.g. xenon flash or laser) whilst in operation.

Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and connectors.

Whilst it is powered, avoid handling the printed circuit board, or only handle it by the edges to minimise the risk of

electrostatic discharge damage.

Physical specifications