76232103 datasheet(6/34 Pages) TOSHIBA

6 / 34 page

- 6 -

7. LED indications

The green and red LED lights on the TV control touchpad

(on the lower right corner of the TV screen)

indicate the TV's current status, as follows:

Green ON Solid (not blinking) = Control touchpad

Red ON Solid (not blinking) = Power ON.

Green and/or Red blinking

(see table below for condition and solution).

VOLUME

CHANNEL

EXIT

TV/VIDEO

POWER

Green indicator

Red indicator

Control touchpad on TV front

LED Indication

Red and Green turn off.

Red light solid and Green off.

Red and Green lights solid.

Green blinks at 1-second intervals;

Red off.

Green blinks at 0.3-second inter-

vals; Red lights solid.

Green lights solid and Red blinks

at 0.5-second intervals.

Green and Red blink at 1-second

intervals.

Red blinks at 0.5-second intervals;

Green off.

Red blinks at 1-second intervals;

Green off.

Red blinks three times; Green off.

Red and Green blink three times.

Condition

Power supply OFF. (AC)

Power supply OFF. (Standby)

(North America)

Power supply ON.

Touched the touchpad

Lamp LPS mode

The lamp is not working properly.

The lamp unit door is not seated

properly. (U)

The lamp is not working properly

after the eight automatic restart

(see item #7). (U)

FAN (Light engine unit) has

stopped.

BUS line is damaged

The color wheel has stopped.

Temperature rises abnormally.

(U) is restoration by the user.

Solution

The TV automatically will try to restart

itself eight times.

Turn the POWER OFF and unplug the power

cord. Review "Lamp Unit Replacement" on

pages 8-10 to ensure that the lamp unit door

is installed securely.

Turn the POWER OFF and then ON again. If

the problem persists, replace the lamp unit

(see pages 8-10).

• Is the output voltage of the supply voltage

regulator for the FAN in the power circuit

normal?

• Has dust accumulated in the FAN?

If the output voltage is not abnormal,

replace the faulty FAN with a new one.

• Check the faulty device through the self

diagnostics function under SERVICE mode.

• Does BUS line (SCL, SDA) work normally?

If the BUS line is under abnor mal

conditions, replace the faulty device with

a new one.

• Is the output voltage of the power supply

circuit normal?

If the output voltage is normal, replace the

engine with a new one.

• Is the ventilating hole in the set (exhaust

slot on the rear) blocked or covered?

• Is FAN rotating normally?

• Has dust accumulated in the ventilating

hole?

If no abnormally conditions are found,

replace the engine with a new one.

being pressed.

76232103 데이터시트(PDF) 6 Page - Toshiba Semiconductor

76232103 데이터시트(HTML) 6 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

데이터시트 다운로드

링크 URL