EVK-R6 - User guide

UBX-21035387 - R02

Appendix

Page 14 of 23

C1-Public

B Setting up cellular packet data connection on

Windows

This section describes how to set up a packet data connection on Windows 10 using the operating

system’s TCP/IP stack and EVK-R6. This is also referred to as a dial-up connection.

The following examples describe how to install and configure two different kinds of modems on

Windows:

1.

Low data rate modem: via the UART interface of the cellular module connected to the Windows

PC by the Cellular USB connector (J501 on EVB) or the Cellular RS232 connector (J500 on EVB)

2.

High data rate modem: via the native USB interface of the cellular module connected to the

Windows PC by the Cellular Native USB connector (J105 on the ADP-R6)

B.1 How to install and configure a low data rate modem

connection

This example describes how to install and configure a low data rate packet data connection on a PC

with the Windows 10 operating system. This uses the TCP/IP stack of the PC over the UART interface

of the cellular module connected to the Windows PC by the Cellular USB connector (J501 on EVB) or

the Cellular RS232 connector (J500 on EVB).

1. Open the Control Panel and select “Phone

and Modem”, go to the Modems tab and

select “Add”.

This opens the Add Hardware Wizard.