| 전자부품 데이터시트 검색엔진 |
|
STM32WB35CCU6A 데이터시트(PDF) 33 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32WB35CCU6A 데이터시트(HTML) 33 Page - STMicroelectronics |
|
33 / 196 page ![]() DS11929 Rev 14 33/196 STM32WB55xx STM32WB35xx Functional overview 57 The system clock after wake-up is 16 MHz, derived from the HSI16. If used, the SMPS is restarted automatically. In this mode the RF can be used. • Shutdown This mode achieves the lowest power consumption. The internal regulator is switched off so that the VCORE domain is powered off. The RTC can remain active (Shutdown mode with RTC, Shutdown mode without RTC). The BOR is not available in Shutdown mode. No power voltage monitoring is possible in this mode, therefore the switch to Backup domain is not supported. SRAM1, SRAM2a, SRAM2b and register contents are lost except for registers in the Backup domain. The device exits Shutdown mode when an external reset (NRST pin), a WKUP pin event (configurable rising or falling edge), or an RTC event occurs (alarm, periodic wake-up, timestamp, tamper). The system clock after wake-up is 4 MHz, derived from the MSI. In this mode the RF is no longer operational. When the RF subsystem is active, it changes the power state according to its needs (Run, Stop, Standby). This operation is transparent for the CPU1 host application and managed by a dedicated HW state machine. At any given time the effective power state reached is the higher one needed by both the CPU1 and RF sub-system. Table 7 summarizes the peripheral features over all available modes. Wake-up capability is detailed in gray cells. Table 7. Features over all modes(1) Peripheral(2) Stop0/Stop1 Stop 2 Standby Shutdown - - - - CPU1 Y - Y - - -- -- -- -- CPU2 Y - Y - - -- -- -- -- Radio system (Bluetooth Low Energy, 802.15.4) YY(3) Y- - Y YY YY(4) Y(4) Flash memory Y (5) YO(6) O(6) R -R -R -R -R SRAM1 Y Y(7) YY(7) R -R -- -- -- SRAM2a Y Y(7) YY(7) R -R -R(8) -- -- SRAM2b Y Y(7) YY(7) R -R -- -- -- Quad-SPI O O O O - -- -- -- -- Backup registers Y Y Y Y R -R -R -R -R Brown-out reset (BOR) Y Y Y Y Y YY YY Y- -- Programmable voltage detector (PVD) O OOO O OO O- -- -- |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |