PicoScope® 6000E Series

Probe positioning system

The Pico oscilloscope probe positioning system holds your circuit board firmly during soldering, inspection and test.

The kits include flexible probe holders which secure magnetically to the steel base plate. When the probes are installed in the holders they can be positioned to make contact with

points of interest on the circuit board and will remain in contact while you make measurements in the PicoScope software.

The large steel base plate is mirror-finished allowing you to see any items such as status LEDs underneath the PCB.

Probe positioning system kit contents:

Item

PQ215 kit

PQ219 kit

PQ218 kit

PCB holder

4

4

Base plate, 210 x 297 mm

1

1

Set of insulation washers for PCB holders

1

1

Pico probe holder, 2.5 mm

4

8

4

Set of cable holders channels A-D

1

1

1

Set of cable holders channels E-H

1

1

1

P2056 500 MHz 10:1 passive BNC probe

4

If you already own a

4- or 8-channel scope

with four probes, this

kit is the ideal add-on.

Upgrade your 8-channel

scope from four to

eight probes, and add

eight probe holders.

Four extra probe

holders.

Passive analog high-impedance probes

P2056 500 MHz and P2036 300 MHz passive probes are supplied with your scope and are also available separately in

single or dual packs. These probes feature a probe-detect readout BNC connector allowing automatic recognition as a

10:1 attenuator by the scope.

Probe connection is confirmed by a notification in PicoScope 6.

Features:

•

Up to 500 MHz bandwidth

•

10:1 attenuation

•

High-frequency response trimmed to match the oscilloscope

•

Probe-detect readout pin for automatic range scaling

A comprehensive selection of accessories is supplied in the single probe packs and a basic selection in the dual packs.

Further accessories are available as listed in the P2056 and P2036 User’s Guide.

Optional accessories