www.ittcannon.com

317

Dimensions are shown in inches (millimeters).

Dimensions subject to change.

MIL-C-81659 Rack and Panel Filter Connectors

TDPX

How to Order - Multiple Gang

FILTER SERIES INDICATOR

T

DPX

4

E

57

57

N

M

P

P

L

-

-

34

00

01

57

57

T

P

P

-

SERIES PREFIX

GANGS IN SHELL

ENVIRONMENTAL

CONTACT ARRANGEMENT

FILTER SERIES INDICATOR

SERIES PREFIX

GANGS IN SHELL

ENVIRONMENTAL

CONTACT ARRANGEMENT

CONTACT ARRANGEMENT

FILTER TYPE

CONTACT TYPE

FILTER TYPE

CONTACT TYPE

CONTACT ARRANGEMENT

FILTER TYPE

CONTACT TYPE

CONTACT ARRANGEMENT

CAPACITANCE INDICATOR

(Side D)

(Side C)

(Side B)

(Side A)

CONTACT TYPE

SHELL TYPE

MODIFICATION NUMBER

POLARIZING POSITION

T - Transverse Monolith

CAPACITANCD INDICATOR (Each gang, as desired)*

L - Low Frequency

M - Mid Frequency

T - Standard Frequency

Note: Use of "T" omitted in past nomen-

clature

H - High Frequency

N - No filter this gang. Standard DPX insert

assembly.

POLARIZING POSITION (see pages 67-68)

MODIFICATION NUMBERS

- 0001 indicates standard design for all styles.

TDPX2-33B:

- 0301 -

Mounting holes .120 dia.

Countersunk 100˚ to .230 dia.

With #4-40 clinch nuts in mounting

holes.

With 6 #4-40 clunch nuts in mount-

ing holes.

With 10 #4-40 clinch nuts in

mounting holes.

- 0101 -

- 0101 -

- 0101 -

TDPX2-34:

TDPX3-34:

TDPX4-34:

CONTACT TYPE

P for pin; S for socket. Designation follows each

arrangement as ordered for 2, 3, or 4 gang

versions. (Printed circuit contact/termiation is

available. Consult factory for specifications.)

SHELL TYPE

33B for male (ARINC B)

34B for female (ARINC B)

33 for male

34 for female

Note: ARINC B specified for DPX2 only.

DPX - DPX series with solder termination.

2, 3, and 4 gang

E - For interfacial (pin)

Delete for standard.

See page 31 for applicable arrangements. Please

specify each arrangement number as indicated in

ordering nomenclature for 2, 3, or 4 gang.

The last two digits in the four-digit dash number

refer to the polarizing post position. When the last

two digits are omitted, the polarizing posts will be

assembled in position 01, but the position number

is not stamped on the connector. This allows the

customer to position the posts themselves nd

then stamp the appropriate number on the shell. If

the last two digits are 00, the polarizing posts are

deleted.