ICSSSTUAF32865A datasheet(4/17 Pages) RENESAS

4 / 17 page

ICSSSTUAF32865A

8-BIT CONFIGURABLE REGISTERED BUFFER FOR DDR2

COMMERCIAL TEMPERATURE GRADE

8-BIT CONFIGURABLE REGISTERED BUFFER FOR DDR2

ICSSSTUAF32865A

7097/1

Ball Assignment

Signal Group

Signal Name

Type

Description

Ungated Inputs

DCKE0, DCKE1,

DODT0, DODT1

SSTL_18

DRAM function pins not associated with Chip Select.

Chip Select Gated

Inputs

D0 ... D21

SSTL_18

DRAM inputs, re-driven only when Chip Select is

LOW.

Chip Select Inputs

DCS0, DCS1

SSTL_18

DRAM Chip Select signals. These pins initiate DRAM

address/command decodes, and as such at least one

will be low when a valid address/command is present.

The register can be programmed to re-drive all

D-inputs only (CSGateEN high) when at least one

Chip Select input is LOW.

Re-Driven

Q0A...Q21A,

Q0B...Q21B,

QCSnA,B

QCKEnA,B,

QODTnA,B

SSTL_18

Outputs of the register, valid after the specified clock

count outputs and immediately following a rising edge

of the clock.

Parity Input

PARIN

SSTL_18

Input parity is received on pin PARIN and should

maintain odd parity across the D0...D21 inputs, at the

rising edge of the clock.

Parity Error

PTYERR

Open Drain

When LOW, this output indicates that a parity error

was output identified associated with the address

and/or command inputs. PTYERR will be active for

two clock cycles, and delayed by an additional clock

cycle for compatibility with final parity out timing on

the industry-standard DDR-II register with parity (in

JEDEC definition).

Program Inputs

CSGateEN

1.8V LVCMOS

Chip Select Gate Enable. When HIGH, the D0..D21

inputs will be latched only when at least one Chip

Select input is LOW during the rising edge of the

clock. When LOW, the D0...D21 inputs will be latched

and redriven on every rising edge of the clock.

Clock Inputs

CLK, CLK

SSTL_18

Differential master clock input pair to the register. The

positive clock input (CLK).

Miscellaneous

Inputs

MCL, MCH

Must be connected to a logic LOW or HIGH.

RESET

SSTL_18

Asynchronous reset input. When LOW, it causes a

reset of the internal latches, thereby forcing the

outputs LOW. RESET also resets the PTYERR

signal.

VREF

0.9V nominal

Input reference voltage for the SSTL_18 inputs. Two

pins (internally tied together) are used for increased

reliability.

ICSSSTUAF32865A 데이터시트(PDF) 4 Page - Renesas Technology Corp

ICSSSTUAF32865A 데이터시트(HTML) 4 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

데이터시트 다운로드

링크 URL