PI6C4512 datasheet(2/4 Pages) PERICOM

2 / 4 page

PI6C4512

PLL Clock Multiplier

PS8763B

03/30/06

Pin Description

Name

Description

X1/ICLK

Crystal connection or clock input.

VCC

Supply voltage: 3.3V ±10% or 5.0V ±10%

GND

Connect to GND

REF

Buffered crystal oscillator output clock

CLK

Clock output

Multiplier select pin 0. Connect to GND or VCC or float (no connection).

Multiplier select pin 1. Connect to GND or VCC or float (no connection).

Crystal connection. Leave unconnected for clock input.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested)

Storage temperature ......................................................-65°C to +150ºC

Ambient Operating Temperature ....................................... 0°C to +70ºC

Supply Voltage to Ground Potential (VCC)..................... -0.3V to +7.0V

Inputs (Referenced to GND)................................... -0.5V to VCC +0.5V

Clock Output (Referenced to GND) ....................... -0.5V to VCC +0.5V

Soldering Temperature (Max of 10 seconds).................................260ºC

Note:

Stresses greater than those listed under MAXIMUM RATINGS

may cause permanent damage to the device. This is a stress rating

only and functional operation of the device at these or any other

conditions above those indicated in the operational sections of this

specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect reliability.

External Components

The PI6C4512 requires a minimum number of external components for proper operation. Decoupling capacitors of 0.1µF || 0.01µF

should be connected between each VDD and GND and placed as close to the chip as possible. A series termination resistor of 33Ω

may be used for clock outputs. If a crystal is used, it should be a fundamental mode, parallel resonant crystal. Crystal capacitors

should be connected from X1 to ground and from X2 to ground to according to the crystal specifications. The value of capacitors is

given by the following equation, where CL is the crystal load capacitance: Crystal caps (pF) = (CL -15) x 2.

Recommended Operation Conditions

Symbol

Description

Test Condition

Min.

Typ.

Max.

Units

VCC

Supply Voltage

5.5

Operating Temperature

+70

°C

06-0034

PI6C4512 데이터시트(PDF) 2 Page - Pericom Semiconductor Corporation

PI6C4512 데이터시트(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4

데이터시트 다운로드

링크 URL