Technical data

Notes

General

The electrical and mechanical data specified assume that the

connector pair is correctly locked and mounted. If the connector

is unlocked and if there is a danger of contamination, the

connector must be sealed using a protective cap > IP54.

Influences arising from litz wires, cables or PCB assembly must

also be taken into consideration.

Safety note

WARNING: The connectors may not be plugged in or

disconnected under load. Ignoring the warning or improper use

may damage persons and/or property.

• WARNING: Commission properly functioning products only.

The products must be regularly inspected for damage.

Decommission defective products immediately. Replace

damaged products. Repairs are not possible.

• WARNING: Only electrically qualified personnel may install and

operate the product. They must observe the following safety

notes. The qualified personnel must be familiar with the basics of

electrical engineering. They must be able to recognize and

prevent danger. The relevant symbol on the packaging indicates

that only personnel familiar with electrical engineering are

allowed to install and operate the product.

• The products are suitable for applications in plant, controller,

and electrical device engineering.

• When operating the connectors in outdoor applications, they

must be separately protected against environmental influences.

• Assembled products may not be manipulated or improperly

opened.

• Only use mating connectors that are specified in the technical

data of the standards listed (e.g. the ones listed in the product

accessories online at phoenixcontact.com/products).

• When using the product in direct connection with third-party

manufacturers, the user is responsible.

• For operating voltages > 50 V AC, conductive connector

housings must be grounded

• Ensure that when laying the cable, the tensile load on the

connectors does not exceed the upper limit specified in the

standards.

• Observe the corresponding technical data. You will find

information:

o On the product

o On the packing label

o In the supplied documentation

o Online at phoenixcontact.com/products under the product

• Only use tools recommended by Phoenix Contact

• Use a protective cap to protect connectors that are not in use.

The suitable accessories are available online in the accessory

section of the product at phoenixcontact.com/products

Safety note

SACCBP-FSD-4CON-PG9/2,0-931SCO - Device

connector, rear mounting

1437708

https://www.phoenixcontact.com/us/products/1437708

Oct 10, 2023, 5:56 AM

Page 2 (12)