| 전자부품 데이터시트 검색엔진 |
|
M29DW128F 데이터시트(PDF) 37 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
M29DW128F 데이터시트(HTML) 37 Page - STMicroelectronics |
|
37 / 94 page ![]() M29DW128F Command interface 37/94 6.2.2 Write to Buffer and Program Confirm command The Write to Buffer and Program Confirm command is used to confirm a Write to Buffer and Program command and to program the N+1 Words/bytes loaded in the Write Buffer by this command. 6.2.3 Write to Buffer and Program Abort and Reset command The Write to Buffer and Program Abort and Reset command is used to abort Write to Buffer and Program command. 6.2.4 Double Word Program command This is used to write two adjacent Words in x16 mode, simultaneously. The addresses of the two Words must differ only in A0. Three bus write cycles are necessary to issue the command: 1. The first bus cycle sets up the command. 2. The second bus cycle latches the Address and the Data of the first Word to be written. 3. The third bus cycle latches the Address and the Data of the second Word to be written and starts the Program/Erase Controller. 6.2.5 Quadruple Word Program command This is used to write a page of four adjacent Words, in x16 mode, simultaneously. The addresses of the four Words must differ only in A1 and A0. Five bus write cycles are necessary to issue the command: 1. The first bus cycle sets up the command. 2. The second bus cycle latches the Address and the Data of the first Word to be written. 3. The third bus cycle latches the Address and the Data of the second Word to be written. 4. The fourth bus cycle latches the Address and the Data of the third Word to be written. 5. The fifth bus cycle latches the Address and the Data of the fourth Word to be written and starts the Program/Erase Controller. 6.2.6 Double byte Program Command This is used to write two adjacent bytes in x8 mode, simultaneously. The addresses of the two bytes must differ only in DQ15A-1. Three bus write cycles are necessary to issue the command: 1. The first bus cycle sets up the command. 2. The second bus cycle latches the Address and the Data of the first byte to be written. 3. The third bus cycle latches the Address and the Data of the second byte to be written and starts the Program/Erase Controller. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |