WM8718

Production Data

w

PD Rev 4.3 November 2006

21

DE-EMPHASIS MODE

Setting the DEEMPH register bit puts the digital filters into de-emphasis mode:

REGISTER ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0010

Mode Control

1

DEEMPH

0

De-emphasis mode select:

0: De-emphasis Off

1: De-emphasis On

POWERDOWN MODE

mode. All trace of the previous input samples is removed, but all control register settings are

preserved. When PWDN is cleared again the first 16 input samples will be ignored, as the FIR

will repeat it's power-on initialisation sequence.

REGISTER ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0010

Mode Control

2

PWDN

0

Power Down Mode Select:

0: Normal Mode

1: Power Down Mode

ZERO FLAG OUTPUTS

The WM8718 has two zero flag outputs pins. The WM8718 asserts a low on the corresponding

zero flag pin when a sequence of more than 1024 mid-rail signal is input to the chip. The user

can use the zero flag pins to control external muting circuits if required.

To simplify external

circuitry there is an option to have both zero flag output’s ANDed internally and output on both

pins.

REGISTER

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0010

Mode

Control

7

ZEROFLR

0

ZERO Flag Outputs:

0: Both pins enabled.

1: AND of both channels to both pins.

ZERO CROSS DETECT

When the WM8718 receives updates to the volume levels it will, by default, wait for the signal to

pass through mid-rail for each channel before applying the update for that particular channel. This

ensures that there is minimum distortion seen on the output when the volume is changed.

REGISTER ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0010

Mode Control

8

ZCDINIT

0

Zero Cross Detect Control:

0: Enabled

1: Disabled

SELECTION OF LRCIN POLARITY

In left justified, right justified or I

this bit is set high, the expected polarity of LRCIN will be the opposite of that shown in Figure 7,

Figure 8 and Figure 9. Note that if this feature is used as a means of swapping the left and right

channels, a 1 sample phase difference will be introduced.

REGISTER ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0011

Format Control

4

LRP

0

LRCIN Polarity (normal)

0: normal LRCIN polarity

1: inverted LRCIN polarity

Table 6 LRCIN Polarity Control

In DSP modes, the LRCIN register bit is used to select between early and late modes (see Figure

10 and Figure 11.