AD600JRZ-R7 datasheet(4/28 Pages) AD

4 / 28 page

AD600/AD602

Rev. E | Page 4 of 28

AD600J/AD602J1

AD600A/AD602A1

Parameter

Conditions

Min

Typ

Max

Min

Typ

Max

Unit

SIGNAL GATING INTERFACE

Logic Input LO (Output On)

0.8

Logic Input HI (Output Off )

2.4

Response Time

On to off, off to on

0.3

μs

Input Resistance

Pin 4 to Pin 3; Pin 5 to Pin 6

kΩ

Output Gated Off

Output Offset Voltage

±10

±100

±10

±400

Output Noise Spectral Density

nV/√Hz

Signal Feedthrough @ 1 MHz

AD600

−80

AD602

−70

POWER SUPPLY

Specified Operating Range

±4.75

±5.25

±4.75

±5.25

Quiescent Current

12.5

1 Specifications shown in boldface are tested on all production units at final electrical test. Results from those tests are used to calculate outgoing quality levels. All

minimum and maximum specifications guaranteed, although only those shown in boldface are tested on all production units.

2 Typical open- or short-circuited input; noise is lower when the system is set to maximum gain and the input is short-circuited. This figure includes the effects of both

voltage and current noise sources.

3 With an additional 1 kΩ pull-down resistor, if RL < 500 Ω.

4 The dc gain of the main amplifier in the AD600 is × 113; therefore, an input offset of only 100 μV becomes an 11.3 mV output offset. In the AD602, the amplifier’s gain

is × 35.7; therefore, an input offset of 100 μV becomes a 3.57 mV output offset.

AD600JRZ-R7 데이터시트(PDF) 4 Page - Analog Devices

AD600JRZ-R7 데이터시트(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

데이터시트 다운로드

링크 URL