Designed, engineered, and

manufactured in Springfield, MO

using U.S. and global components.

LT-0377 21523

738A ADEMCO

INTERFACE MODULE

Specifications

Primary Power

12 VDC

Current Draw

75 mA

Dimensions

5.50” W x 3.00” H x 0.75” D

13.97 cm W x 7.62 cm x H x 1.91 cm D

Accessories

Model 300

4‑Wire Harness

Compatibility

XR150/XR550 Series panels

XT30/XT50 Series panels with firmware Version 101 or higher

Certifications

FCC Part 15

MODEL 738A

INTRUSIO N • FIR E • ACCES S • NETWORKS

2500 North Partnership Boulevard

Springfield, Missouri 65803‑8877

800.641.4282 | DMP.com

FCC INFORMATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.

This device may not cause harmful interference, and

2. this device must accept any interference received, including interference that may cause undesired operation.

The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm (7.874 in.) from

all persons. It must not be located or operated in conjunction with any other antenna or transmitter.

Changes or modifications made by the user and not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

1.

Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.