Fig. 1 Pin Configurations

Symbol

Description

-IN

Negative (inverting) input.

+IN

Positive (noninverting) input.

-INA, -INB

-INC, IND

Inverting Input of the Amplifier. The Voltage range can go from (VS– – 0.1V) to (VS+ + 0.1V).

+INA, +INB

+INC, +IND

Non-Inverting Input of Amplifier. This pin has the same voltage range as –IN.

+VS

Positive Power Supply. The voltage is from 2.5V to 5.5V. Split supplies are possible as long as the

voltage between VS+ and VS– is between 2.5V and 5.5V. A bypass capacitor of 0.1μF as close to the

part as possible should be used between power supply pins or between supply pins and ground.

-VS

Negative Power Supply. It is normally tied to ground. It can also be tied to a voltage other than

ground as long as the voltage between VS+ and VS– is from 2.5V to 5.5V. If it is not connected to

ground, bypass it with a capacitor of 0.1μF as close to the part as possible.

OUT

Output.

OUTA, OUTB

OUTC, OUTD

Amplifier Output.

www.umw-ic.com

2

UTD Semiconductor Co.,Limited

LMV721

LMV722

LMV724

SOT23-5/SC70-5

SOP-8/TSSOP-8/MSOP-8

SOP-14/TSSOP-14

LMV721, LMV722, LMV724

10MHz, RRIO CMOS Operational Amplifiers

UMW

R

-VS