USB3280 datasheet(39/42 Pages) SMSC

39 / 42 page

Hi-Speed USB Device PHY with UTMI Interface

Datasheet

SMSC USB3280

Revision 1.2 (10-27-06)

DATASHEET

8.12

Detection of Resume

Resume signaling always takes place in FS mode (TERMSELECT and XCVRSELECT = FS enabled),

so the behavior for a HS device is identical to that of a FS device. The SIE uses the LINESTATE

signals to determine when the USB transitions from the 'J' to the 'K' state and finally to the terminating

FS EOP (SE0 for 1.25us-1.5µs.).

The resume signaling (FS 'K') will be asserted for at least 20ms. At the beginning of this period the

SIE may negate SUSPENDN, allowing the transceiver (and its oscillator) to power up and stabilize.

The FS EOP condition is relatively short. SIEs that simply look for an SE0 condition to exit suspend

mode do not necessarily give the transceiver’s clock generator enough time to stabilize. It is

recommended that all SIE implementations key off the 'J' to 'K' transition for exiting suspend mode

(SUSPENDN = 1). And within 1.25µs after the transition to the SE0 state (low-speed EOP) the SIE

must enable normal operation, i.e. enter HS or FS mode depending on the mode the device was in

when it was suspended.

If the device was in FS mode: then the SIE leaves the FS terminations enabled. After the SE0 expires,

the downstream port will assert a J state for one low-speed bit time, and the bus will enter a FS Idle

state (maintained by the FS terminations).

If the device was in HS mode: then the SIE must switch to the FS terminations before the SE0 expires

( < 1.25µs). After the SE0 expires, the bus will then enter a HS IDLE state (maintained by the HS

terminations).

8.13

HS Device Attach

Figure 8.8 demonstrates the timing of the USB3280 control signals during a device attach event. When

a HS device is attached to an upstream port, power is asserted to the device and the device sets

XCVRSELECT and TERMSELECT to FS mode (time T1).

VBUS is the +5V power available on the USB cable. Device Reset in Figure 8.8 indicates that VBUS is

within normal operational range as defined in the USB 2.0 specification. The assertion of Device Reset

(T0) by the upstream port will initialize the device. By monitoring LINESTATE, the SIE state machine

knows to set the XCVRSELECT and TERMSELECT signals to FS mode (T1).

The standard FS technique of using a pull-up resistor on DP to signal the attach of a FS device is

employed. The SIE must then check the LINESTATE signals for SE0. If LINESTATE = SE0 is asserted

at time T2 then the upstream port is forcing the reset state to the device (i.e. Driven SE0). The device

will then reset itself before initiating the HS Detection Handshake protocol.

USB3280 데이터시트(PDF) 39 Page - SMSC Corporation