XC4E datasheet(28/116 Pages) AEROTECH

28 / 116 page

Chapter 2: Installation and Configuration

XC4e Hardware Manual

2.1.2. Motor Supply Connector

Motor power is applied to the AC1 and AC2 terminals of the XC4e Motor Supply connector. The XC4e10

AC1 input is internally connected to a 5 A fuse. The XC4e20/30 AC1 input is internally connected to a 10 A

fuse. Refer to Table 5-2 for the internal fuse part numbers. The AC2 input is not internally fused. An external

fuse is required if AC2 is not connected to Neutral.

DANGER: Before you operate the XC4e, install a ground connection for your safety and to

prevent damage to the equipment.

For CE compliance, Aerotech recommends that you use an AC line filter. Connect the filter as close as

possible to the drive. For more information about the AC line filter, refer to Section 2.1.4.

NOTE: Refer to local electrical safety requirements to correctly size external system wires.

Figure 2-2:

Motor Supply Connections

Table 2-3:

Motor Supply Connector Wiring Specifications

Description

Recommended Wire Size

AC1

0-240 VAC Motor Power Input

0.5 mm2 (#20 AWG)

AC2

Neutral (N) or 240 VAC Motor Power Input with external fuse

0.5 mm2 (#20 AWG)

Protective Ground

0.5 mm2 (#20 AWG)

Table 2-4:

Mating Connector Part Numbers for the Motor Supply Connector

Type

Aerotech P/N

Third Party P/N

Screw Torque

Value: Nm

Wire Size:

mm2[AWG]

7-Pin Terminal Block

ECK02387

Phoenix 1756353

0.5 - 0.6

3.3 - 0.0516 [12-30]

XC4E 데이터시트(PDF) 28 Page - AEROTECH US. ALL RIGHTS RESERVED.