Type 8007

7 | 10

Visit product website 

5.

Product installation

5.1. Mounting options

Note:

In order to get the accuracy specified in the data sheets, the sensor must be inserted in the centre of a straight pipe section with an

undisturbed gas stream.

To obtain an undisturbed gas stream the sections in front of and behind the sensor must be straight, long enough and without any

obstructions such as edges, seams, curves etc.

Careful attention must be paid to the design of the outlet section as obstructions can cause counter-flow turbulences as well as

turbulences in the direction of the flow.

Installation in pipes at pressures > 10 bar requires a high pressure safety device.

5.2. Installation notes

Note:

In order to maintain the accuracies specified in the data sheets, the sensor must be inserted centrally in a straight piece of pipe at a

point with undisturbed flow.

45 x DN 5 x DN

35 x DN 5 x DN

20 x DN 5 x DN

15 x DN 5 x DN

15 x DN 5 x DN

15 x DN 5 x DN

Control valve

2 × 90°

elbow joint

3 dimensional

2 × 90°

elbow joint

90° elbow joint

or T-piece

Pipe diameter

expansion

Pipe diameter

reduction

DN = pipe diameter

Flow direction 