| 전자부품 데이터시트 검색엔진 |
|
SAA7712 데이터시트(PDF) 13 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
SAA7712 데이터시트(HTML) 13 Page - NXP Semiconductors |
|
13 / 44 page ![]() 1999 Aug 05 13 Philips Semiconductors Preliminary specification Sound effects DSP SAA7712H 8.1.5 PERFORMANCE The signed-magnitude noise-shaped DAC has a dynamic range in excess of 100 dB. The signal-to-noise ratio of the audio output at full-scale is determined by the word length of the converter. The noise at low outputs is fully determined by the noise performance of the DAC. Since it is a signed-magnitude type, the noise at digital silence is also low. As a disadvantage, the total THD is higher than conventional DACs. The typical total harmonic distortion-plus-noise to signal ratio as a function of the output level is shown in Fig.6. Fig.6 Typical (THD + N)/S curve as a function of the output level. handbook, halfpage −80 −60 −40 0 MGS211 −20 −60 −80 −40 −20 (THD + N)/S (dB) output level (dB) 8.1.6 POWER-ON MUTE (POM) To avoid any uncontrolled noise at the audio outputs after power-on of the IC, the reference current source of the DAC is switched off. The capacitor on pin POM determines the time after which this current has a soft switch-on. So at power-on the current audio signal outputs are always muted. The loading of the external capacitor is done in two stages via two different current sources. The loading starts at a current level that is 9 times lower than the current loading after the voltage on pin POM has passed the 1 V level. This results in an almost dB linear behaviour. 8.1.7 POWER-OFF PLOP SUPPRESSION Power should still be provided to the analog part of the DAC, while the digital part is switching off. As a result, the output voltage will decrease gradually allowing the power amplifier some extra time to switch-off without audible plops. If a 5 V power supply is present, the supply voltage of the analog part of the DAC can be fed from the 5 V power supply via a 1.8 V zener diode. A capacitor, connected to the 3.3 V power supply, provides power to the analog part when the 5 V power supply is switching off fast. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |