TMP112BIDRLR datasheet(21/46 Pages) TI1

21 / 46 page

7.4 Device Functional Modes

7.4.1 Continuous-Conversion Mode

The default mode of the TMP112 family is continuous conversion mode. During continuous-conversion mode,

the ADC performs continuous temperature conversions and stores each results to the temperature register,

overwriting the result from the previous conversion. The conversion rate bits, CR1 and CR0, configure the

TMP112 family for conversion rates of 0.25 Hz, 1 Hz, 4 Hz, or 8 Hz. The default rate is 4 Hz. The TMP112

family has a typical conversion time of 10 ms for both SOT563-6 and X2SON-5 packages. To achieve different

conversion rates, the TMP112 family makes a conversion and then powers down and waits for the appropriate

delay set by CR1 and CR0. Table 7-5 lists the settings for CR1 and CR0.

Table 7-5. Conversion Rate Settings

CR1

CR0

CONVERSION RATE

0.25 Hz

1 Hz

4 Hz (default)

8 Hz

After a power-up or general-call reset, the TMP112 family immediately begins a conversion as shown in Figure

7-7. The first result is available after 10 ms (typical). The active quiescent current during conversion is 55 μA

(typical at 27°C) for both SOT563-6 and X2SON-5 packages. The quiescent current during delay is 2.6 μA

(typical at 27°C) for SOT563-6 and X2SON-5 packages.

Start of

Conversion

Startup

Delay

(1)

10ms

Figure 7-7. Conversion Start

7.4.2 Extended Mode (EM)

The extended mode bit configures the device for normal mode operation (EM = 0) or extended mode operation

(EM = 1). In normal mode, the temperature register and the high and low limit registers use a 12-bit data format.

Normal mode is used to make the TMP112 family compatible with the TMP75 device.

Extended mode (EM = 1) allows measurement of temperatures above 128°C by configuring the temperature

7.4.3 One-Shot/Conversion Ready Mode (OS)

The TMP112 family features a one-shot temperature-measurement mode. When the device is in shutdown

mode, writing a 1 to the OS bit begins a single temperature conversion. During the conversion, the OS bit reads

0. The device returns to the SHUTDOWN state at the completion of the single conversion. After the conversion,

the OS bit reads 1. This feature is useful for reducing power consumption in the TMP112 family when continuous

temperature monitoring is not required.

As a result of the short conversion time, the TMP112 family can achieve a higher conversion rate. A single

conversion typically occurs 10 ms for both SOT563-6 and X2SON-5 packages, and a read can occur in less than

20 μs. When using one-shot mode, 80 or more conversions per second are possible.

www.ti.com

TMP112, TMP112D

SBOS473L – MARCH 2009 – REVISED JULY 2024

Submit Document Feedback

Product Folder Links: TMP112 TMP112D

TMP112BIDRLR 데이터시트(PDF) 21 Page - Texas Instruments

TMP112BIDRLR 데이터시트(HTML) 21 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

데이터시트 다운로드

링크 URL