24AA00-SLASHST datasheet(5/22 Pages) MICROCHIP

5 / 22 page

 2004 Microchip Technology Inc.

DS21226E-page 5

24LCS61/24LCS62

3.5

Acknowledge

Each receiving device, when addressed, is required to

generate an acknowledge after the reception of each

byte. The master device must generate an extra clock

pulse which is associated with this Acknowledge bit.

The device that acknowledges has to pull down the

SDA line during the Acknowledge clock pulse in such a

way that the SDA line is stable low during the high

period of the acknowledge related clock pulse.

course, setup and hold times must be taken into

account. A master must signal an end of data to the

slave by not generating an Acknowledge bit on the last

byte that has been clocked out of the slave. In this

case, the slave must leave the data line high to enable

the master to generate the Stop condition (Figure 3-2).

FIGURE 3-2:

ACKNOWLEDGE TIMING

Note:

The 24LCS61/62 does not generate any

Acknowledge bits if an internal program-

ming cycle is in progress.

SCL

Transmitter must release the SDA line at this point

allowing the Receiver to pull the SDA line low to

acknowledge the previous eight bits of data.

Receiver must release the SDA line at this point

so the Transmitter can continue sending data.

Data from transmitter

SDA

Acknowledge

Bit

24AA00-/ST 데이터시트(PDF) 5 Page - Microchip Technology