PS200 datasheet(17/36 Pages) MICROCHIP

17 / 36 page

DS21891B-page 15

PS200

5.0

ELECTRICAL SPECIFICATIONS

Absolute Maximum Ratings†

Ambient temperature under bias................................................................................................................. -40 to +125°C

Storage temperature .............................................................................................................................. -65°C to +150°C

Voltage on VDD with respect to VSS ............................................................................................................ -0.3 to +6.5V

Voltage on RESET with respect to Vss ......................................................................................................-0.3 to +13.5V

Voltage on HVOUT with respect to Vss ........................................................................................................... 0V to +8.5V

Voltage on all other pins with respect to VSS ................................................................................. -0.3V to (VDD + 0.3V)

Total power dissipation(1) ..................................................................................................................................... 800 mW

Maximum current out of VSS pin ........................................................................................................................... 300 mA

Maximum current into VDD pin .............................................................................................................................. 250 mA

Input clamp current, IIK (VI < 0 or VI > VDD)

...................................................................................................................... ±20 mA

Output clamp current, IOK (Vo < 0 or Vo >VDD)

................................................................................................................ ±20 mA

Maximum output current sunk by any I/O pin...................................................................................................... 25 mA(2)

Maximum output current sourced by each Port .................................................................................................. 50 mA(2)

Note 1: Power dissipation is calculated as follows: PDIS = VDD x {IDD –

∑ IOH} + ∑ {(VDD – VOH) x IOH} + ∑(VOL x IOL).

2: Total source current must not exceed the shunt regulator capacity.

5.1

Reliability Targets

5.2

Design Targets

† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the

device. This is a stress rating only and functional operation of the device at those or any other conditions above

those indicated in the operation listings of this specification is not implied. Exposure to maximum rating conditions for

extended periods may affect device reliability.

The device must be designed to target the following reliability specifications:

ESD:

±4000V HBM

±400V MM

all pins including VDD, VSS, RESET

Latch-up: ±400 mA @ 125°C

The AC/DC specifications included in the following sections are preliminary specifications that we intend to publish

at product introduction. As the product matures, we intend to expand the specifications. Therefore, design should

try and meet the following extended VDD/temperature targets:

Frequency of operation: DC – 4 MHz, VDD = 2.0V – 5.5V, -40°C to 125°C

Frequency of operation: DC – 20 MHz, VDD = 4.5V – 5.5V, -40°C to 125°C

PS200 데이터시트(PDF) 17 Page - Microchip Technology

PS200 데이터시트(HTML) 17 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

데이터시트 다운로드

링크 URL