MCP23008-ESLASHML datasheet(17/44 Pages) MICROCHIP

17 / 44 page

DS21919D-page 17

MCP23008/MCP23S08

1.6.8

INTERRUPT FLAG (INTF)

The INTF register reflects the interrupt condition on the

port pins of any pin that is enabled for interrupts via the

GPINTEN register. A ‘set’ bit indicates that the

associated pin caused the interrupt.

This register is ‘read-only’. Writes to this register will be

ignored.

Note:

INTF will always reflect the pin(s) that

have an interrupt condition. For example,

one pin causes an interrupt to occur and is

captured in INTCAP and INF. If before

clearing the interrupt another pin changes,

which would normally cause an interrupt, it

will be reflected in INTF, but not INTCAP.

INTF – INTERRUPT FLAG REGISTER (ADDR 0x07)

R-0

INT7

INT6

INT5

INT4

INT3

INT2

INT1

INT0

bit 7

bit 0

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

-n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

bit 7-0

INT7:INT0: These bits reflect the interrupt condition on the port. Will reflect the change only if interrupts

are enabled (GPINTEN) <7:0>.

1 = Pin caused interrupt.

0 = Interrupt not pending.

MCP23008-E/ML 데이터시트(PDF) 17 Page - Microchip Technology

MCP23008-E/ML 데이터시트(HTML) 17 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

데이터시트 다운로드

링크 URL