MCP3551-ESLASHMS datasheet(21/30 Pages) MICROCHIP

21 / 30 page

DS21950D-page 21

MCP3550/1/3

5.5

Using The MCP3550/1/3 with

Microcontroller (MCU) SPI Ports

It is required that the microcontroller SPI port be config-

ured to clock out data on the falling edge of clock and

latch data in on the rising edge. Figure 5-6 depicts the

operation shown in SPI mode 1,1, which requires that

the SCK from the MCU idles in the High state, while

Figure 5-7 shows the similar case of SPI Mode 0,0,

where the clock idles in the Low state. The waveforms

in the figures are examples of an MCU operating the

SPI port in 8-bit mode, and the MCP3550/1/3 devices

do not require data in 8-bit groups.

In SPI mode 1,1, data is read using only 24 clocks or

three byte transfers. The data ready bit must be read

by testing the SDO/RDY line prior to a falling edge of

the clock.

In SPI mode 0,0, data is read using 25 clocks or four

byte transfers. Please note that the data ready bit is

included in the transfer as the first bit in this mode.

FIGURE 5-6:

SPI Communication – Mode 1,1.

FIGURE 5-7:

SPI Communication – Mode 0,0.

SCK

SDO/RDY

MCU

Data stored into MCU receive

first byte

Receive

Buffer

Data stored into MCU receive

second byte

Data stored into MCU receive

third byte

DO O

21 20 19 18 17

15 14 13 12 11 10 9

7 6 543

2 1

OL OH 21 20 19 18 17 16

15 14 13 12 11 10 9

RH L

SCK

SDO/RDY

MCU

Data stored into MCU receive

first byte

Receive

Buffer

Data stored into MCU receive

second byte

Data stored into MCU receive

third byte

Data stored into MCU receive

fourth byte

21 20 19 18 17

14 13 12 11 10 9

654 3 2

OH OL 21 20 19 18 17

15 14 13 12 11 10 9

MCP3551-E/MS 데이터시트(PDF) 21 Page - Microchip Technology

MCP3551-E/MS 데이터시트(HTML) 21 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

데이터시트 다운로드

링크 URL