PIC18F44J10-ESLASHML datasheet(151/358 Pages) MICROCHIP

151 / 358 page

Preliminary

DS39682C-page 149

PIC18F45J10 FAMILY

15.3.3

ENABLING SPI I/O

To enable the serial port, MSSP Enable bit, SSPEN

(SSPxCON1<5>), must be set. To reset or reconfigure

SPI mode, clear the SSPEN bit, reinitialize the

SSPxCON registers and then set the SSPEN bit. This

configures the SDIx, SDOx, SCKx and SSx pins as

serial port pins. For the pins to behave as the serial port

function, some must have their data direction bits (in

the TRIS register) appropriately programmed as

follows:

• SDIx is automatically controlled by the SPI module

• SDOx must have TRISC<5> (or TRISD<2>) bit

cleared

• SCKx (Master mode) must have TRISC<3> (or

TRISD<0>) bit cleared

• SCKx (Slave mode) must have TRISC<3> (or

TRISD<0>) bit set

•SSx must have TRISA<5> (or TRISD<3>) bit set

Any serial port function that is not desired may be

overridden by programming the corresponding data

direction (TRIS) register to the opposite value.

15.3.4

TYPICAL CONNECTION

Figure 15-2 shows a typical connection between two

microcontrollers. The master controller (Processor 1)

initiates the data transfer by sending the SCKx signal.

Data is shifted out of both shift registers on their pro-

grammed clock edge and latched on the opposite edge

of the clock. Both processors should be programmed to

the same Clock Polarity (CKP), then both controllers

would send and receive data at the same time.

Whether the data is meaningful (or dummy data)

depends on the application software. This leads to

three scenarios for data transmission:

• Master sends data – Slave sends dummy data

• Master sends data – Slave sends data

• Master sends dummy data – Slave sends data

FIGURE 15-2:

SPI™ MASTER/SLAVE CONNECTION

Serial Input Buffer

(SSPxBUF)

Shift Register

(SSPxSR)

MSb

LSb

SDOx

SDIx

PROCESSOR 1

SCKx

SPI™ Master SSPM3:SSPM0 = 00xxb

Serial Input Buffer

(SSPxBUF)

Shift Register

(SSPxSR)

LSb

MSb

SDIx

SDOx

PROCESSOR 2

SCKx

SPI™ Slave SSPM3:SSPM0 = 010xb

Serial Clock

PIC18F44J10-E/ML 데이터시트(PDF) 151 Page - Microchip Technology

PIC18F44J10-E/ML 데이터시트(HTML) 151 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL