DSPIC30F2011 datasheet(93/205 Pages) MICROCHIP

93 / 205 page

DS70139E-page 91

dsPIC30F2011/2012/3012/3013

13.3

Slave Select Synchronization

The SS1 pin allows a Synchronous Slave mode. The

SPI must be configured in SPI Slave mode with SS1

pin control enabled (SSEN = 1). When the SS1 pin is

low, transmission and reception are enabled and the

SDOx pin is driven. When SS1 pin goes high, the

SDOx pin is no longer driven. Also, the SPI module is

resynchronized, and all counters/control circuitry are

reset. Therefore, when the SS1 pin is asserted low

again, transmission/reception will begin at the MSb

even if SS1 had been de-asserted in the middle of a

transmit/receive.

13.4

SPI Operation During CPU Sleep

Mode

During Sleep mode, the SPI module is shut down. If the

CPU enters Sleep mode while an SPI transaction is in

progress, then the transmission and reception is

aborted.

The transmitter and receiver will stop in Sleep mode.

However, register contents are not affected by entering

or exiting Sleep mode.

13.5

SPI Operation During CPU Idle

Mode

When the device enters Idle mode, all clock sources

remain functional. The SPISIDL bit (SPI1STAT<13>)

selects if the SPI module will stop or continue on idle. If

SPISIDL = 0, the module will continue to operate when

the CPU enters Idle mode. If SPISIDL = 1, the module

will stop when the CPU enters Idle mode.

DSPIC30F2011 데이터시트(PDF) 93 Page - Microchip Technology