PI3A412E datasheet(2/9 Pages) PERICOM

2 / 9 page

PS8804B

12/06/06

PI3A412E

0.5Ω, 3.3V, Quad SPDT Analog Switch with Enable

Caution: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a

stress only rating and operation of the device at these or any other conditions beyond those indicated in the operational sections of

this speciﬁcation is not implied.

Absolute Maximum Ratings

Voltages Referenced to GND

VCC .................................................................... –0.5V to +4.6V

VNC, VNO, VCOM (1)....................................–0.5V to V+ +0.3V

.................................................or 30mA, whichever occurs ﬁrst

Current (any terminal)................................................... ±400mA

Peak Current

(Pulsed at 1ms, 10% duty cycle)................................... ±500mA

Note 1: Signals on NC, NO, COM, or EN1, A0 exceeding VCC or GND are clamped by internal diodes. Limit forward diode current to 30mA.

Thermal Information

Continuous Power Dissipation

16-pin Tin TQFN (derate 7.1mW/ºC above +70ºC) ........... 0.5W

Storage Temperature ........................................–65ºC to +150ºC

Lead Temperature (soldering, 10s) ................................. +300ºC

Electrical Speciﬁcations - Single +4.2V Supply

(VCC = +4.2V ± 10%, GND = 0V, VIH = 1.4V, VIL = 0.7V) (TA = –40°C to +85°C)

Parameter

Symbol

Conditions

Min.(1)

Typ. (2)

Max. (1) Units

Analog Switch

Analog Signal Range (3)

VANALOG

0VCC

On Resistance

RON

VCC = 4.0V, ICOM = 100mA,

VNC = +1.5V

0.4

0.5

On-Resistance Match Between

Channels(4)

ΔRON

0.01

0.03

On-Resistance Flatness(5)

RFLAT(ON)

VCC = 4.0V, ICOM = 100mA,

VNC = 0.8V, 2.0V

0.06

0.15

Off Leakage Current(6)

INO(OFF),

or INC(OFF)

VCC = 4.4V,

VNO or VNC = 0.3V, 3.3V

-200

200

On Leakage Current(6)

ICOM(ON)

VCC = 4.4V,

VNO or VNC = 0.3V, 3.3V

-200

200

Notes:

The algebraic convention, where most negative value is a minimum and most positive is a maximum, is used in this data sheet.

Typical values are TA = 25°C, VCC = 4.2V unless otherwise speciﬁed.

Guaranteed by design.

ΔRON = RON match between channels

Flatness is deﬁned as the difference between the maximum and minimum value of On-Resistance measured.

Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at +25ºC.

06-0322

PI3A412E 데이터시트(PDF) 2 Page - Pericom Semiconductor Corporation

PI3A412E 데이터시트(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6 7 8 9

데이터시트 다운로드

링크 URL