ICS1893CF datasheet(52/126 Pages) ICST

52 / 126 page

ICS1893CF, Rev. F, 03/01/07

Mar. 2007

Chapter 7 Management Register Set

ICS1893CF Data Sheet - Release

7.3.6 IEEE Reserved Bits (bits 1.10:7)

The IEEE reserves these bits for future use. When an STA:

• Reads a reserved bit, the ICS1893CF returns a logic zero.

• Writes a reserved bit, the STA must use the default value specified in this data sheet.

Both the ISO/IEC standard and the ICS1893CF reserve the use of some Management Register bits. ICS

uses some reserved bits to invoke ICS1893CF test functions. To ensure proper operation of the

ICS1893CF, an STA must maintain the default value of these bits. Therefore, ICS recommends that an STA

write the default value to all reserved bits during all Management Register write operations.

Reserved bits 1.10:7 are Command Override Write (CW) bits. When bit 16.15, the Command Register

Override bit, is logic:

• Zero, the ICS1893CF prevents all STA writes to CW bits.

• One, an STA can modify the value of these bits.

7.3.7 MF Preamble Suppression (bit 1.6)

Status Register bit 1.6 is the Management Frame (MF) Preamble Suppression bit. The ICS1893CF sets bit

1.6 to inform the STA of its ability to receive frames that do not have a preamble. When this bit is logic:

• Zero, the ICS1893CF is indicating it cannot accept frames with a suppressed preamble.

• One, the ICS1893CF is indicating it can accept frames that do not have a preamble.

Although the ICS1893CF supports Management Frame Preamble Suppression, its default value for bit 1.6

is logic zero. This default value ensures that bit 1.6 is backward compatible with the ICS1890, which does

not have this capability. As the means of enabling this feature, the ICS1893CF implements bit 1.6 as a

Command Override Write bit, instead of as a Read-Only bit as in the ICS1890. An STA uses the bit 1.6 to

enable MF Preamble Suppression in the ICS1893CF. [See the description of bit 16.15, the Command

Override Write Enable bit, in Section 7.11, “Register 16: Extended Control Register”.]

7.3.8 Auto-Negotiation Complete (bit 1.5)

An STA reads bit 1.5 to determine the state of the ICS1893CF auto-negotiation process. The ICS1893CF

sets the value of this bit using two criteria. When its Auto-Negotiation sublayer is:

• Disabled, the ICS1893CF sets bit 1.5 to logic zero.

• Enabled, the ICS1893CF sets bit 1.5 to a value based on the state of the Auto-Negotiation State

Machine. In this case, it sets bit 1.5 to logic one only upon completion of the auto-negotiation process.

This setting indicates to the STA that a link is arbitrated and the contents of Management Registers 4, 5,

and 6 are valid. For details on the auto-negotiation process, see Section 6.2, “Functional Block:

Auto-Negotiation”.

Bit 1.5 is a latching high (LH) bit. (For more information on latching high and latching low bits, see Section

7.1.4.1, “Latching High Bits” and Section 7.1.4.2, “Latching Low Bits”.)

Note: An Auto-Negotiation Restart does not clear an LH bit. However, performing two consecutive reads

of this register provides the present state of the bit.

ICS1893CF 데이터시트(PDF) 52 Page - Integrated Circuit Systems