PCF8534H datasheet(19/40 Pages) PHILIPS

19 / 40 page

PCF8534_0

Preliminary datasheet

Rev. 00.05 — 20 February 2007

19 of 40

NXP Semiconductors

PCF8534

Universal LCD driver for low multiplex rates

Application design-in information

7.1 Characteristics of the I2C bus

The I2C-bus is for bidirectional, two-line communication between different ICs or modules.

The two lines are a Serial Data line (SDA) and a Serial Clock Line (SCL). Both lines must

be connected to a positive supply via a pull-up resistor when connected to the output

stages of a device. Data transfer is initiated only when the bus is not busy.

7.2 Bit transfer

One data bit is transferred during each clock pulse.

The data on the SDA line must remain stable during the HIGH period of the clock pulse as

changes in the data line at this time will be interpreted as a control signal. Bit transfer is

illustrated in Figure 11.

7.3 START and STOP conditions

Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW

transition of the data line, while the clock is HIGH is defined as the START condition (S).

A LOW-to-HIGH transition of the data line while the clock is HIGH is defined as the STOP

condition (P). The START and STOP conditions are illustrated in Figure 12.

7.4 System configuration

A device generating a message is a ‘transmitter’, a device receiving a message is the

‘receiver’. The device that controls the message is the ‘master’ and the devices which are

controlled by the master are the ‘slaves’. The system configuration is illustrated in

Figure 13.

Fig 11. Bit transfer

mba607

data line

stable;

data valid

change

of data

allowed

SDA

SCL

Fig 12. Definition of START and STOP conditions

mbc622

SDA

SCL

STOP condition

SDA

SCL

START condition

PCF8534H 데이터시트(PDF) 19 Page - NXP Semiconductors

PCF8534H 데이터시트(HTML) 19 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

데이터시트 다운로드

링크 URL