PI3CH200LE datasheet(4/8 Pages) PERICOM

4 / 8 page

PS8721C

05/10/06

PI3CH200

Low Voltage, 5Ω, 2-Channel

2-Port NanoSwitch™

Switching Characteristics over 2.5V Operating Range

Parameters

Description

Conditions(1)

Com.

Units

Min.

Max.

tPLH

tPHL

Propagation Delay(2,3) Ax to Bx, Bx to Ax

See Test Diagram

0.3

tPZH

tPZL

Enable Time ENx to Ax or Bx

See Test Diagram

1.5

15.0

tPHZ

tPLZ

Disable Time ENx to Ax or Bx

1.5

12.0

Switching Characteristics over 3.3V Operating Range

Parameters

Description

Conditions(1)

Com.

Units

Min.

Typ.

Max.

tPLH

tPHL

Propagation Delay(2,3) Ax to Bx, Bx to Ax

See Test Diagram

0.3

tPZH

tPZL

Enable Time ENx to Ax or Bx

See Test Diagram

1.5

9.0

tPHZ

tPLZ

Disable Time ENx to Ax or Bx

1.5

9.0

Notes:

1. See test circuit and waveforms.

2. This parameter is guaranteed but not tested on Propagation Delays.

3. The switch contributes no propagational delay other than the RC delay of the On-Resistance of the switch and the load

capacitance. The time constant for the switch alone is of the order of 0.25ns for 10pF load. Since this time constant is much

smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational

delay of the switch when used in a system is determined by the driving circuit on the driving side of the switch and its

interaction with the load on the driven side.

Dynamic Electrical Characteristics Over the Operating Range (TA = –40º to +85º, VCC = 3.3V ± 10%)

Parameter

Description

Test Condition

Min.

Typ.

Max.

Units

XTALK

Crosstalk

See Test Diagram

–60

OIRR

Off-Isolation

See Test Diagram

–60

–3dB Bandwidth

See Test Diagram

200

500

MHz

Notes:

1. See test circuit and waveforms.

2. This parameter is guaranteed but not tested on Propagation Delays.

3. The switch contributes no propagational delay other than the RC delay of the On-Resistance of the switch and the load

capacitance. The time constant for the switch alone is of the order of 0.25ns for 10pF load. Since this time constant is much

smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational

delay of the switch when used in a system is determined by the driving circuit on the driving side of the switch and its

interaction with the load on the driven side.

06-0246

PI3CH200LE 데이터시트(PDF) 4 Page - Pericom Semiconductor Corporation

PI3CH200LE 데이터시트(HTML) 4 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6 7 8

데이터시트 다운로드

링크 URL